Barudan Support

Many times, nothing other than a broken needle or bent presser foot results from hitting the hoop. If this happens, simply replace the needle, and straighten out the presser foot and continue. If sewing problems continue after this, more serious damage such as a broken needle bar driver may have...

The information in this article applies to the following machine models: Barudan Multi-head machines, generally 12 heads or more SUMMARY Many larger Barudan embroidery machines, typically 12 or more heads, are supplied with 3 phase transformers. These provide the smoothest power to the machine, and are more efficient. Customers purchasing...

Proper Lubrication will help your machine last a long time and avoid costly repairs. We've removed covers in some of the photographs to help show where to oil. We suggest that you may want to do the same- remove the cover to be sure that you're oiling the proper place....

The information in this article applies to the following machine models: Barudan B2000 Single head Zig-Zag Embroidery machines Meistergram models Single head Zig-Zag Embroidery machines SUMMARY This page provides a list of all fuses used in the Zig-Zag machines produced under the Meistergram and Barudan Labels.  Fuses provide electrical protection...

On the name plate there is a serial number. For American built machines, the first two digits of the serial number represent the year the machine was manufactured. The last digit, if it is a letter, represents the month in which the machine was manufactured. The letters A-M are used...

For machines with 9 needles or less: There are three tensioners for the top thread: The upper, center, and the lower (or rotary) tensioner. Most adjustments are done with the upper and/or center tensioners. The general rule is; what you do to the upper, you should do to the center,...

There is a "NAME PLATE" on every machine, which lists the model name, serial number, and power specifications. On single heads, it is located just underneath the table top fastened to the metal frame. On multi-headed machines, it is located on the metal frame near the center of the machine,...

Your machine is installed with a time clock that prompts you to call and get a password to disable the clock after a certain time period. The message you see is a warning letting you know the time clock is about to expire. Once the time clock expires, you will...

The information in this article applies to the following product: Barudan BEDT-ZQ-501 Elite Pro single head embroidery machine SUMMARY This document shows the locations and service intervals for lubricating the BEDT-ZQ-501 "Elite Pro" machine. This information has been updated since the first machine shipments.   BEDT-ZQ-501 (Elite Pro) LUBRICATION CHART...

What is wrong? What should I do? (BEAT 900 series only) Typically this can be corrected by a simple "System Reset" To do a "System Reset": Power off your machine, power back on, tap the Scroll Lock key until the Scroll Lock light comes on. The machine will boot up...

The information in this article applies to the following machine models:   Barudan N Series Multihead Embroidery machines: BENS, BENY, BENR, BENB Barudan BENT/ ELITE Single Head Embroidery machines   SUMMARY Improper needle depth can cause a variety of sewing problems. This procedure details how to check if the needle...

Thread break detection is done by the check spring. If the check spring is sitting against its post, then the machine assumes the thread is broken. If the machine consistently is not recognizing thread breaks on a particular needle, look at the check spring area. Be sure the spring can...

It is recommended that you shut your machine off at the breaker if it is not going to be in use for an extended period of time to protect it from extreme electrical influences such as lightning.